Short answer. Wipe the bench and floor with a slightly damp cloth, sit on towels, and leave the door open after each use. Never put water on the heaters. With that routine, an indoor cabin commonly lasts 10 to 20 years, and the parts most likely to need replacing along the way are electronics, not wood.
Key facts
- To clean an infrared sauna, wipe the bench, backrest and floor with a soft cloth that is only slightly damp, with the power off and the cabin cool.
- Water should never be poured or sprayed on infrared sauna heaters, and wet cleaning near the heaters can void the warranty.
- Sitting on a towel and putting a second towel on the floor of an infrared sauna prevents most sweat stains on the wood.
- A well kept indoor infrared sauna is commonly expected to last about 10 to 20 years, although there is no official lifespan standard.
- The parts that most often fail first in an infrared sauna are the control panel, the power supply, the lights and the audio system, not the wood cabin.
How do you clean an infrared sauna?
Switch it off, let it cool, then wipe the surfaces you touch with a soft cloth that is only slightly damp. That is most of the job. An infrared cabin is a dry room, so there is no scale, no drain and no stones to deal with.
- Power off. Turn the cabin off at the control panel. For a full clean, switch it off at its power switch or unplug it as well.
- Wipe bench, backrest and floor. Use plain water on a wrung-out cloth. Wipe along the grain.
- Dry. Follow with a dry cloth so no moisture stays on the wood.
- Floor. Vacuum or sweep. Lift out the floor mat or duckboard if there is one.
- Glass. Clean the door and windows with glass cleaner sprayed on the cloth, not on the door, so no mist reaches the wood.
- Air out. Leave the door open until the cabin is dry.
Always follow the manual of your model first. Some makers name the cleaners they allow.
How often should you clean it?
A quick wipe after each use and a fuller clean about once a month suits most homes. Adjust to how often the cabin is used.
| When | What to do |
|---|---|
| Every session | Sit on a towel, put a towel on the floor, wipe any sweat off the wood, leave the door open for a while |
| Weekly | Wipe bench, backrest and door handle with a damp cloth. Vacuum or sweep the floor |
| Monthly | Clean the glass. Dust the heater guards with a dry cloth or soft brush, power off. Look for stains |
| Once or twice a year | Check screws, latches and hinges. Check the power cord and plug for heat marks. Lightly sand stains |
| Outdoor cabins, yearly | Inspect roof, seals and exterior finish as the maker directs |
Why do towels matter so much?
Because bare wood soaks up sweat and skin oils, and those leave dark marks. The interior is left unfinished, so nothing stops a stain from sinking in.
- Sit on a towel that covers the bench.
- Put a second towel under your feet.
- Hang a towel on the backrest if you lean on it.
- Step in clean and dry, without lotion or oil on your skin.
- Wash the towels after each session.
Pale woods such as hemlock and basswood show marks sooner than cedar. See infrared sauna wood types.
Can you use water on the heaters?
No. Never pour, spray or splash water on the heaters or the control panel. An infrared cabin is not built for water the way a traditional sauna with stones is. Water on live electrical parts is a shock and damage risk, and most warranties exclude it.
To clean the heater guards, switch the power off, wait until they are cool and dust them with a dry cloth or a soft brush. If something spills on a heater, switch off the power and contact the maker before you use the cabin again.
Other things to avoid
- Bleach, ammonia and solvent cleaners, which can mark the wood and leave fumes in a closed cabin.
- Soaking, hosing or pressure washing.
- Varnish, paint or oil on the interior, unless the maker says so.
- Drying wet clothes or towels on the heaters.
- Essential oils dripped on the wood or the heaters.
How do you remove stains from sauna wood?
Start mild. Wipe with a damp cloth and a little mild soap, then with clean water, then dry. If the mark stays, sand it lightly along the grain with fine sandpaper and wipe away the dust. Sanding removes a thin layer of wood, so do it only where needed. For anything stronger, ask the maker what is safe for that wood.
How long do infrared saunas last?
A well kept indoor cabin is commonly expected to last about 10 to 20 years. There is no official standard behind that range. It reflects what sellers quote and the fact that a dry cabin puts little stress on wood.
Three things decide where a cabin lands in that range:
- Placement. A dry, heated room is easiest on wood and electronics. Damp or unheated spaces are harder. See garage or basement placement.
- Build. Wall thickness, joints and the quality of the electronics.
- Spare parts. A cabin lasts as long as you can get a control board or heater for it.
What wears out first?
Electronics and moving parts, long before the wood. The usual order looks like this:
- Lights. Bulbs and LED strips.
- Audio. Speakers and Bluetooth modules, which often have the shortest warranty.
- Control panel and power supply. The most common reason a cabin stops heating.
- Connectors and wiring plugs. A loose plug can take out one heater.
- Door hardware. Hinges, magnets, handles and seals.
- Heaters. Individual panels can fail, though carbon panels tend to last. See carbon vs ceramic heaters.
Can parts be replaced?
Usually yes. Most cabins are modular: heaters, control panels and power supplies plug into a wiring harness and can be swapped. Before you order anything:
- Find the model and serial number on the rating label.
- Check the warranty. Many cover the part but not the labor or the shipping. See warranty and certifications.
- Order the part from the maker or an authorized seller, by model number.
- Unplug the cabin or switch off its breaker before any work.
- Have a licensed electrician do anything beyond a plug-in swap, and any work on a 240 volt or hardwired cabin.
If one heater stays cold, note which one and whether the others work before you call. That detail helps the maker tell a failed panel from a loose connector or a control fault.
Common questions
How do you clean an infrared sauna?
Switch it off and let it cool. Wipe the bench, backrest and floor with a soft, slightly damp cloth, vacuum or sweep the floor, clean the glass, and leave the door open to air out. Do not use harsh cleaners or soak the wood.
How often should you clean an infrared sauna?
Wipe the bench and floor after each use or at least once a week, and do a fuller clean about once a month. Wash the towels after every session.
Can you use water or cleaning spray inside an infrared sauna?
Use very little. A lightly damp cloth is fine on the wood. Never spray or pour anything on the heaters or the control panel, and avoid bleach, ammonia and strong scented cleaners unless the manual lists them.
How long do infrared saunas last?
A well kept indoor cabin is commonly expected to last about 10 to 20 years. No official standard exists, so the written warranty and the availability of spare parts are the firm facts to compare.
Can you replace a heater in an infrared sauna?
Usually yes. On most cabins the heater panels plug into a wiring harness and can be swapped one by one. Order the part by model number from the maker, and have an electrician do any work beyond a plug-in swap.



